玻璃鋼滑梯是兒童水上游樂園內的一種非常受歡迎的設施，當然它的使用也是很頻繁的，因此安全就是大家很關心的事情，下面兒童水上游樂設施廠家為您講解下玻璃鋼滑梯的保養和維修。

The glass fiber reinforced plastic slide is a very popular facility in the Children's Water Park. Of course, it is also used frequently. Therefore, safety is a matter of great concern. Now, the manufacturer of children's water recreation facilities will explain the maintenance and repair of the glass fiber reinforced plastic slide.

玻璃鋼滑梯的保養：

Maintenance of FRP slide:

1、每日開放前，應對滑梯進行檢查，察看滑梯有無外露的銳邊、尖角、毛刺、漏水等現象。

1. Before opening every day, the slide shall be checked to see whether there are exposed sharp edges, sharp corners, burrs, water leaks, etc.

2、水處理設備是否正常運轉，以保障滑梯潤滑水及滑梯落水池的水的供給。

2. Whether the water treatment equipment operates normally to ensure the supply of lubricating water for the slide and water for the slide sump.

3、對連接件要定期檢查并緊固。

3. Regularly check and fasten the connectors.

4、對承重構件應定期檢查，看結構有無裂紋產生以及彎曲變形等。以便及時更換。

4. The load-bearing components shall be inspected regularly to see if there are cracks and bending deformation in the structure. For timely replacement.

5、滑梯在非使用期間應用塑料布或粗布遮蓋以防止紫外線照射造成滑梯老化、褪色、產生裂紋等。對有裂紋的滑梯槽段應及時更換（或修補），滑梯接口不平整、倒凸臺或有裂口時應及時處理。

5. The slide shall be covered with plastic cloth or coarse cloth during non use to prevent the slide from aging, fading and cracking caused by ultraviolet radiation. The chute section with cracks shall be replaced (or repaired) in a timely manner, and the interface of the slide shall be treated in a timely manner in case of unevenness, inverted boss or cracks.

6、金屬構件表面漆層在非使用期間應檢查是否有脫落、褪色，若有剝皮、脫落現象應補漆。

6. The paint layer on the surface of metal components shall be checked for peeling and fading during non use, and the paint shall be repaired in case of peeling and fading.

7、要定期組織安全檢查維護，發現滑梯道面有積水、有砂石、水垢等，應及時用棉布或砂紙清理、打磨。

7. Regularly organize safety inspection and maintenance. If water, sand and scale are found on the surface of the slide, they should be cleaned and polished with cotton cloth or sandpaper.

玻璃鋼滑梯的維修：

Repair of FRP slide:

1、滑梯漏水：連接玻璃膠老化，先鏟除舊膠，并清理干凈，重新打玻璃膠密封，用手抹平，對殘余的玻璃膠要進行刮除，待干燥后用水砂紙進行表面打磨處理。

1. Water leakage of slide: when the glass glue is aged, remove the old glue first, clean it up, seal it with glass glue again, level it with hands, scrape off the residual glass glue, and polish the surface with sandpaper after it is dry.

2、滑梯裂紋：用角磨機先把裂紋打磨掉，在修補前把打磨的表面清理干凈（用毛刷或棉布），再用同顏色膠衣進行修補，固化后，先用400#水砂紙進行粗打磨，再800#水砂紙進行半精打磨，后用1500#水砂紙進行精打磨，以達到滑梯表面平整、光滑，后用拋光機（配3#拋光液）進行拋光處理。

2. Slide cracks: use an angle grinder to polish off the cracks, clean the polished surface (with a brush or cotton cloth) before repair, and then use gel coat of the same color to repair. After curing, first use 400 # water abrasive paper for rough grinding, then 800 # water abrasive paper for semi fine grinding, and then use 1500 # water abrasive paper for fine grinding, so that the slide surface is flat and smooth, and then use a polishing machine (with 3 # polishing liquid) for polishing.

玻璃鋼滑梯的保養和維修指南就整理到這里了，您對此有什么不了解的地方或者有什么需求就來我們網站http://www.979yy.cn進行咨詢吧！

Here is the maintenance and repair guide for the fiberglass slide. If you have any questions or needs, please come to our website http://www.979yy.cn Consult!